From a home steam iron that's stopped producing steam to a hotel laundry's ironing system, FETSCO repairs steam irons, ironing centres and pressing equipment.
Likely cause: Limescale blocking the steam vents, or a failed steam pump/boiler on ironing-system units.
How we fix it — We descale the unit fully and test the steam pump or boiler, replacing whichever component has failed.
Likely cause: A cracked water tank, a faulty steam valve, or condensation from an overfilled tank.
How we fix it — We identify the specific leak source and repair or replace the part at fault.
Likely cause: A failed heating element or thermostat.
How we fix it — We test and replace the element or thermostat as needed.
Likely cause: Mineral (limescale) build-up inside the tank and steam chamber.
How we fix it — We carry out a full descale and flush of the internal system.
Ironing systems and industrial units draw significant power — we confirm the circuit is correctly rated before setup.
Boiler filled and pressure-tested before first use on ironing-centre and industrial units.
Unit positioned with a stable, heat-safe surface and, for commercial units, correct clearance.
Steam pressure and output tested across the full range before handover.
Usually limescale or mineral deposits being pushed out with the steam — a descale resolves this in most cases; using filtered or distilled water helps prevent it recurring.
Yes — including boiler-fed ironing centres and pressing equipment, with AMC options for commercial laundries.
For most faults, yes — descaling and element/valve repairs are inexpensive relative to a new unit.
Use filtered or distilled water where possible, and descale every few months depending on use — we can also do this as part of a service visit.
Same-day slots available in most areas across the UAE.