Dishes coming out dirty, water pooling at the bottom, or a machine that won't start — FETSCO repairs and installs built-in and freestanding dishwashers from every major brand.
Likely cause: A blocked spray arm, worn wash pump, or hard-water residue building up inside the machine.
How we fix it — We clear the spray arms and filter, test the wash pump, and advise on a descaling routine if hard water is the cause.
Likely cause: A blocked filter/drain hose, or a failed drain pump — very similar cause to a washing machine's drainage fault.
How we fix it — We clear the blockage and test the drain pump, replacing it if it's failed rather than just blocked.
Likely cause: A worn door seal, or the machine slightly out of level so water escapes at the lowest point.
How we fix it — We replace the door seal and re-level the unit as needed.
Likely cause: A faulty door latch/interlock, a tripped thermal fuse, or a control board fault.
How we fix it — We test the door latch and control board first — a latch replacement is often a same-visit fix.
We confirm the cabinet opening, water supply and drain point match the new unit before installation begins.
Inlet and drain lines connected and pressure-tested for leaks.
The unit is levelled so the door seals correctly and, for built-in units, the front panel aligns with surrounding cabinetry.
We run a full cycle to confirm fill, wash, drain and dry all work correctly before handover.
Usually trapped food debris in the filter or spray arms — we clean this as part of a service visit, and a monthly empty hot cycle with dishwasher cleaner helps prevent it.
Yes — built-in and integrated dishwasher installation to match your existing cabinet fronts.
That's usually hard-water limescale, not a fault — a rinse-aid top-up and a periodic descale usually resolves it; we can advise during a service visit.
Yes, both.
Same-day slots available in most areas across the UAE.